Table of Contents
Advertisement
The PBX uses Price per minute for internal calculations and display
purposes during calls that are initiated by an LCR subscriber and perhaps a
Call Through user and routed via the corresponding provider.
The Price per minute refers to the currency entered in the PBX (Functions
> Call allowance accounts under CHARGES).
Metering pulse interval 1st pulse
Proceed as follows:
•
Separately for main provider, 1st and 2nd fallback provider
Seconds the provider assigns the first meter pulse after the connection has
been established (after CONNECT).
Note: This meter pulse is fully billed by the provider even if the call is
ended before this time has elapsed.
Second pulse
Proceed as follows:
•
Separately for main provider, 1st and 2nd fallback provider
Charge pulse time unit used to bill a call after the first metering pulse.
Note:
For second pulses of differing lengths, enter the most unfavourable
meter pulse.
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Settings – Routing
Soft-LCR 4.0
809
Advertisement
Table of Contents
