Table of Contents
Advertisement
Important: To use this function on ISDN and system phones, the
function must be supported via a function key or via the menu by the
respective phone (optional, see manual for the phone).
4. Proceed as required.
• To disconnect the third call and go back to the query call with the
previously active communication partner, press the Flash key or the
Query key and dial 1.
You then make a query call with the communication partner
who had previously been active. The call with the third commu-
nication partner is disconnected.
• To disconnect the third call and go back to the query call with the
communication partner who had previously been on hold, press the
Flash key or the Query key and dial 2.
You will then make a query call with the communication partner
who had previously been on hold. The call with the third
communication partner is disconnected.
• To disconnect the previous calls and make an one-on-one call with
the third communication partner, press the Flash key or the Query
key and dial 0.
You are making an one-on-one call with the third communi-
cation partner. The previous calls have been disconnected.
• To connect the third communication partner to the second communi-
cation partner, press the Flash key or the Query key and dial 4.
The second and the third communication partner are now
connected with each other. They are making an one-on-one
call with the first communication partner.
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Phoning
Query Calls
271
Advertisement
Table of Contents
