Table of Contents
Advertisement
After picking up the receiver (when a special tone has been configured
as notification that call forwarding, do-no-disturb or baby call has been
switched on)
After picking up the receiver (when a special dial tone has been
enabled), when the call data memory is full
•
Call waiting tone: During a call (when call waiting has been enabled),
when another call comes in – it is possible to accept or reject the
additional call
•
Changing tone:
During a Call Through call, when the phone number transferred from the
mobile phone is permitted to use Call Through - dialling a phone number
is possible
During a remote programming call, when the connection for remote
programming is available – programming is possible
Proceed as follows for configuration:
•
Making settings for tones.
– Using the Configuration Manager (page Subscriber (scr.) >
Properties > Settings)
The tones are signaled as follows:
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Functions, Uses, Concepts
Tones
185
Advertisement
Table of Contents
