Settings – Devices
Announcement Outputs
A relay with the operating mode Speaking, which is enabled during the
loudspeaker announcement, is assigned to the alarm. This relay can be
used to switch over the loudspeaker area of the loudspeaker system, for
example, or to switch on an additional lamp which draws attention to the
announcement.
If suitable relays have already been configured on the page Devices >
Relays (Actuators), a list field will appear now. Select one of the existing
relays and click
If you do not want to use any of the existing relays, select New relays in the
list field (
cancels the operation). Enter a freely selectable name for the
relay and click Ok.
Note: Alternatively, you can also create and assign relays on the page
Devices > Relays (Actuators).
For a detailed description of the operating modes, refer to the chapter
Functions, Uses, Concepts > Relays (Actuators) > Relay Operating
Modes.
Link to the page Devices > Relays (actuators)
Deletes the relay or opens the configuration of the relay.
756
.
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018