Table of Contents
Advertisement
2TSM Modul
Switching duration
Specifies after how many seconds the PBX will switch off the relay. Possible
entries: 0 bis 6000 (0 only for manual relays).
Notes:
The switching duration is used for relays with the operating modes Light,
Door opener, Alarm, PC relay and Manual relay.
To enable the PBX to switch off the relay after the specified switching
duration, off control must be supported by the relay and be switched on
(for some relays, e. g. the a/b Switching Modules, switching off cannot
be controlled). Alternatively, the hold time of the relay can be used.
Analogue Door Terminal
Off control
Requirements:
•
Created relay
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Settings – Devices
Relays (Actuators)
773
Advertisement
Table of Contents
