Table of Contents
Advertisement
Loudspeaker Announcement
This function enables loudspeaker announcements over an active
loudspeaker (for example, a loudspeaker system in a waiting room). In
addition, a previously specified phone number is called by an internal
phone. The call connection is immediately established after dialling the
phone number.
In order to make loudspeaker announcements, a device that can be used as
announcement output (e. g. an a/b-Audiobox at a loudspeaker system)
must be connected to the PBX. This announcement output must be created
in the configuration of the PBX and assigned an internal number to call it.
Proceed as follows for configuration:
•
Creating an announcement output with internal number.
– Using the Configuration Manager (page Devices > Device wizard)
•
Creating a relais and assigning it to an announcement output.
– Using the Configuration Manager (page Devices > Announcement
outputs)
•
If necessary, making additional settings for the announcement output.
– Using the Configuration Manager (page Devices > Announcement
outputs)
•
Switching the authorisation for speaker announcements for the involved
internal phones on.
– Using the Configuration Manager (page Subscriber (scr.) >
Properties > Authorisations)
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Functions, Uses, Concepts
Loudspeaker Announcement
125
Advertisement
Table of Contents
