Auerswald COMmander 6000 Advanced Information page 780

Settings – Devices
Relays (Actuators)
To enable the PBX to switch off the relay after the specified switching
duration, off control must be supported by the relay and be switched on
(for some relays, e. g. the a/b Switching Modules, switching off cannot
be controlled). Alternatively, the hold time of the relay can be used.
Hold time
If switching off is not to be controlled by the PBx (for some relays, e. g. the
a/b Switching Modules, switching off cannot be controlled), the hold time of
the relay can be used instead of the switching duration. This will only make
sense if the hold time of the relay is sufficiently long, for example for a door
opener.
The PBX needs to know how long the relay will be held in order to signalise
holding of the relay on the system phones (see the manual of the device in
question).
Requirements:
• Created relay
• Off control switched on for the relay
Enter the hold time of the relay in milliseconds. Possible entries: 10 to 10000
ms.
Relay can be triggered by Action URL

Provided that the access authorisation to Action URLs is granted
system-wide or for a subscriber, the individual manual relay can be triggered
by Action URLs.
780
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018