Table of Contents
Advertisement
Call Allowance Account
A call allowance account is a restricted amount of currency units (credit) that
is configured for each phone. As soon as the configured credit is used up, it
is no longer possible to make external calls on the corresponding phone
until the credit has been increased or reset.
If the remaining amount is used up during a call, the subscriber hears a short
attention tone repeatedly. Afterwards, the call is disconnected.
Note:
Some phone service providers do not transmit charges. If this provider
type is used (by manual selection) for making calls, a configured call
allowance account will not apply to the call in question. To avoid this, the
provider phone numbers in question should be entered as restricted
numbers and this function should be enabled for every phone.
If the LCR procedure Soft-LCR 4.0 is used, the charges are calculated
based on the length of the call and the tariff table set up separately. For
this purpose, you need to specify a price per minute as well as the length
of the charge pulse per switching time and provider.
Proceed as follows for configuration:
•
Configuring LCR.
– Using the Configuration Manager (page Routing > Soft-LCR 4.0)
•
Making settings for call allowance accounts.
– Using the Configuration Manager (page Functions > Call
allowance accounts)
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Functions, Uses, Concepts
Call Allowance Account
77
Advertisement
Table of Contents
