Table of Contents
Advertisement
Routing
Use Soft LCR 4.0 for this connection
Requirements:
•
Network provider must support the dial-around service
•
Configured prefixes (country prefix and local area code)
•
Configured LCR (see Functions, Uses, Concepts > LCR section)
The ISDN connection is used for LCR calls.
Notes:
LCR must be disabled if the network provider does not support LCR.
However, you can always perform LCR manually by dialling a provider
area code prefix if the network provider supports the dial-around service.
LCR provider digit-recognition for this connection
Requirements:
•
Disabled Adopt settings from PBX location (Germany)
The digits in the table below are the common LCR number prefixes in
Germany. For other countries, more LCR number prefixes (a total of 10) can
be entered.
Digit number
5
6
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Digits begin with
010
0100
Settings – Public switched tel. networks
ISDN connections
441
Advertisement
Table of Contents
