Settings Announcement Output - Auerswald COMmander 6000 Advanced Information

Pbx for internet/isdn telephony

Hide thumbs Also See for COMmander 6000:

Table of Contents

Settings Announcement Output

Proceed as follows:

Separately for announcement outputs

Using the Configuration Manager (page Devices > Announcement

outputs > Configure)

Requirements:

Created announcement output

CONFIGURATION OF THE ANNOUNCEMENT OUTPUT

Select the announcement output you want to configure.

Enable connection

Finish connection

Specifies which DTMF sequences the PBX uses to control the analogue

announcement outputs to enable or terminate the connection. For infor-

mation about which DTMF sequences the connected device requires, see

the manual of the device in question.

Note: You can use the comma ',' character as a pause of half a second.

COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018

Settings – Devices

Announcement Outputs

Commander 6000r