Settings – User Data
Address Books
Information about Transfer via LDAP Server
For the transfer of contact data from the LDAP server of the PBX to the IP
end device you have to enter the following values into the end device.
For the transfer of all selected contact groups (e. g. in the factory settings).
•
User name
•
BaseDN
dc=auerswald
•
Password
auerswaldsecret
For the transfer of single contact groups (e. g. for contact group DECT1):
•
User name
•
BaseDN
ou=DECT1,dc=auerswald
•
Password is configurable
For the transfer of contacts of a single subscriber (e. g. for the internal
number 31):
•
User name
•
BaseDN
phoneNumber=31,dc=auerswald
•
In this case the password is the user password of the subscriber.
Note:
You must enter the complete character string.
Ensure you type the capital and lower-case letters correctly, and do not
type any blank spaces before or after the
In order to avoid input errors, on page User data > Address books >
Settings, in the lines below the entry and list fields you can mark and
copy the user name and BaseDN.
954
cn=auerswaldschandelah,dc=auerswald
cn=DECT1,dc=auerswald
phoneNumber=31,dc=auerswald
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
,
and
=
characters.