Table of Contents
Advertisement
b.
balancing: The order phones are called is managed by a
dynamic priority list. After each accepted call, the corre-
sponding phone is moved to the last position in line.
x.
_.
without rotating: After the first loop (all logged-in phones have
been/are ringing) is complete, the call is disconnected. Busy
subscribers hear no knocking.
y.
_.
Proceed as follows for configuration:
•
Configuring ringing sequence, priority and ringing delay for the existing
groups.
– Using the Configuration Manager (page Groups > Properties >
Basic settings)
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
rotating: After the first loop (all logged-in phones have
been/are ringing) is complete, it is started again. In the
second loop, the busy subscribers hear knocking. The
call is terminated by the network provider (usually after
120 sec.).
Split Group: During the call phase, the group needs to be
reachable for further callers. Group splitting makes sure
that approximately the same number of subscribers is
available for each of the upcoming calls.
without Split Group: A second caller hears the busy
signal (only possible for All).
Functions, Uses, Concepts
Ringing Sequence
103
Advertisement
Table of Contents
