Table of Contents
Advertisement
Functions, Uses, Concepts
Call Distribution
Call Distribution
In call distribution, you specify which internal subscribers should be given
the signal for an incoming external call. This means that in call distribution,
you specify, e.g., permanently, which internal phones should ring when you
are called. Call distribution for each phone number is configured individually
on a connection with multiple external numbers (e.g., ISDN connection).
You can configure both one phone for multiple phone numbers and multiple
phones (group) for one phone number to ring.
Requirements:
•
Configured external numbers:
– Using the Configuration Manager (on the following pages)
– Public switched tel. networks > ISDN connections
– Public switched tel. networks > Voice over IP (VoIP)
•
Configured internal numbers:
– Using the Configuration Manager (on the following pages)
– Subscriber (scr.) > Phone numbers
– Groups > Phone numbers
Proceed as follows for configuration:
•
Creating the call distribution.
– Using the Configuration Manager (page Public switched tel.
networks > Call distribution)
•
Setting the fallback.
– Using the Configuration Manager (page Public switched tel.
networks > Call distribution)
170
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Advertisement
Table of Contents
