Table of Contents
Advertisement
Settings – Devices
Relays (Actuators)
Specifies how many milliseconds the pbx will wait before it sends DTMF
sequences to the connected device again. Possible entries: 0 to 10000 milli-
seconds.
Switching
The PBX uses DTMF sequences to control the analogue relays. For this
purpose, the PBX needs to know which DTMF sequences the connected
device requires to switch the relay on or off (see the manual of the device in
question).
Requirements:
•
Created analogue relay
Switch on, Switch off
Enter DTMF sequences required by the connected device. Possible entries:
Digits and the characters * and # and the comma ',' character as a pause of
half a second.
VoIP Door Terminal
PBX acts as master
The available relays on an IP switch relay can also be toggled without
affecting the PBX. In some situations, e.g. if the PBX is switched off at the
switching point, the PBX cannot identify the state of the relay.
The PBX restores the relay to the last state it was able to identify after
it is rebooted.
776
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Advertisement
Table of Contents
