Table of Contents
Advertisement
Settings – Devices
Door Terminals
CONFIGURATION OF THE DOOR TERMINAL
Analogue door terminals
Enable connection
Finish connection
Specifies which DTMF sequences the PBX uses to control the analogue
door terminal to enable or terminate the connection. For information about
which DTMF sequences the connected device requires, see the manual of
the device in question.
Note: You can use the comma ',' character as a pause of half a second.
Dead time
Specifies how many milliseconds the PBX will wait before it sends DTMF
sequences to the door terminal again. For information about how much time
the connected device requires to be ready for reception again after receiving
DTMF sequences, see the manual of the device in question.
VoIP door terminals
SIP password
To create a connection with a VoIP door terminal, the PBX needs the SIP
password of the connected device (see manual and settings of the device
in question).
748
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Advertisement
Table of Contents
