Table of Contents
Advertisement
New
Adds a new alarm. You must then make the settings for this new alarm.
Delete
Deletes the entries marked in the list.
Switch input+Relay
Relay
Requirements:
•
Relay/actuator (optional, see chapter Technical Data in the Instructions)
•
Created device (e. g. door terminal, IP switch relay) whose part the
relay is
A relay with the operating mode Alarm, which is used to enable e. g. a siren
when the alarm has been triggered, is assigned to the alarm.
In the list field, select one of the existing relays and click
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Settings – Devices
Alarms
.
761
Advertisement
Table of Contents
