Settings Door Call - Auerswald COMmander 6000 Advanced Information

Settings Door Call

Proceed as follows:
• Separately for door calls
• Using the Configuration Manager (page Devices > Door terminals >
Door terminal calls >
Requirements:
• Configured door call
CONFIGURATION OF THE DOOR CALL
Select the door call you want to configure.
Level
Requirements:
• Created switch input for a COMmander 2TSM(R) module
The level must be configured depending on the signal applied.
High level
A voltage of 5-15 V AC/DC was applied.
Low level
GND was applied.
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
)
Settings – Devices
Door Terminals
749