Table of Contents
Advertisement
Renew call forwarding at PBX reboot
When rebooting the PBX, the saved data of the call forwarding is
renewed.
Important: In Switzerland, the configuration of a call forwarding is
chargeable. To avoid costs, the check box must be disabled.
Delay time for Call Forwarding on no reply in the PBX
This delay time for external numbers specifies the time (in seconds) after
which a call is forwarded if the called subscriber does not respond.
Note: The waiting time applies only to call forwarding that was set up
using the PBX. If the network provider has configured the call forwarding
function, the waiting time depends on their settings and cannot be
configured in the PBX.
Routing via exception numbers (VoIP + GSM)
Requirements:
•
Configured exception numbers (page Routing > VoIP and GSM
Routing > Exception numbers)
•
Enabled call forwarding method 2. B channel
The device checks whether the destination number involved in call
forwarding for external numbers has been set up as an exception number.
If so, the call is sent along the configured path. If the destination number has
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Settings – Public switched tel. networks
Voice over IP (VoIP)
539
Advertisement
Table of Contents
