Table of Contents
Advertisement
•
Created device (e. g. a door terminal) whose part the switch input is
(e. g. a still free door bell button)
A switch input that can be used to trigger the alarm, is assigned to the alarm.
In the list field, select one of the existing switch inputs and click
If you do not want to use any of the existing switch inputs, select New
switch input in the list field (
selectable name for the switch input and select the device as whose part the
switch input is to be created in the Add to list field.
Enter a value under DTMF sequence (for analogue door terminals) or SIP
invite (for VoIP door terminals). To detect that the alarm has been triggered,
e. g. because a door bell button has been pressed, the PBX needs to know
which DTMF sequence or which SIP invite the connected device sends in
this case (see manual and settings of the device in question). The DTMF
sequence or the SIP invite usually is the phone number assigned to the door
bell button within the door terminal.
Click Ok.
Note: The switch input remains part of this other device (e. g. door
terminal) in the configuration of the PBX, but takes over the selected
alarm function for the alarm.
Deletes the switch input or opens the configuration of the switch input.
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
cancels the operation). Enter a freely
Settings – Devices
Alarms
.
763
Advertisement
Table of Contents
