Functions, Uses, Concepts
Ringtones
Proceed as follows for configuration:
•
Configuring the ringing tone for external calls.
– Using the Configuration Manager (on the following pages)
– Public switched tel. networks > ISDN connections > PTMP
connection
– Public switched tel. networks > ISDN connections > PBX base
numbers/trunk bundles > Configure
– Public switched tel. networks > ISDN connections > Extension
numbers PTP connection
– Public switched tel. networks > ISDN connections > Additional
PBX base numbers
– Public switched tel. networks > Voice over IP (VoIP) > Accounts
•
Configuring the ringing tone for internal calls.
– Using the Configuration Manager (page Subscriber (scr.) >
Properties > Analogue Settings)
•
Configuring the ringing tone for door calls.
– Using the Configuration Manager (page Devices > Door terminals)
•
Configuring the ringer frequency.
– Using the Configuration Manager (page Subscriber (scr.) > All
subscribers)
Note: For alarm calls the ringing tone is permanently set as Alarm.
112
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018