Table of Contents
Advertisement
Settings – Devices
Device Wizard
Configure Loudspeaker Announcements
In order to make loudspeaker announcements, a device that can be used as
announcement output (e. g. an a/b-Audiobox at a loudspeaker system)
must be connected to the PBX. This announcement output must be created
in the configuration of the PBX and assigned an internal number to call it.
The announcement output can be created with the device wizard. Various
devices supported by the PBX that can be used as announcement output
are available as device templates for this purpose. Their factory settings
already include several default values for operation of the announcement
outputs.
If no of the device templates on offer matches your installation, you can
select a user-defined device template.
If you use the announcement output of a COMmander 2TSM (R) module,
the announcement output is created when configuring the module (see
chapter Settings - Devices > Device Wizard > Device Wizard Management
> Configure 2TSM Module).
Phone number
This is an internal number. You can select any of the numbers in the internal
supply of phone numbers. This number can be called directly by an internal
subscriber. (Entry on page Devices > Device wizard)
Notes:
A number cannot be allocated twice.
Using numbers with few digits (two- or three-digit numbers) inevitably
restricts the possible supply of numbers that require more digits. For
example, if the phone number 12 is assigned, the phone numbers 120
to 129 and 1200 to 1299 are no longer available.
740
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Advertisement
Table of Contents
