Table of Contents
Advertisement
Configuration Manager
Introduction to the Configuration Manager
Since the administrator may block parts of the PBX, you may not be able
to configure all of the settings in the Configuration Manager if you are
logged in as a user or a sub-administrator (see chapter Administration >
Access authorisations)
Open the Configuration Manager as an Administrator
1. Enter the IP address of the PBX (for example, 192.168.0.240).
2. Enter the admin user name and the corresponding password.
Opening the Configuration Manager as Sub-Administrator
1. Enter the IP address of the PBX (for example, 192.168.0.240).
2. Enter the user name
Note: If the sub-administrator enters his own internal number as his user
name, this login is recognised as a user login and the web interface is
displayed for the user.
Opening the Configuration Manager as User
1. Enter the IP address of the PBX (for example, 192.168.0.240).
378
sub-admin
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
and the corresponding password.
Advertisement
Table of Contents
