Table of Contents
Advertisement
Ringer frequency
Specifies the ringer voltage frequency the PBX uses to signalise calls to
internal analogue subscribers.
ISDN scr may move with phone/change ports
The ISDN devices may be connected to any internal S0/UP0 port. The
PBX recognises the subscriber and moves him to another port.
An ISDN device may be plugged into another RJ socket of the internal
S0/UP0 port, but it has to be the same internal bus.
Delay time for baby / senior call (1..20 sec.)
Specifies after how many seconds the destination number is dialled
automatically after picking up the receiver
Differently configurable functions for private and business calls
Two different configurations can be created for each of the functions
listed below – one for private calls and one for business calls.
Only one configuration can be created for the functions listed below.
This applies to private calls as well as to business calls.
Note:
If differently configurable functions for private and business calls are
disabled, the PBX takes over the configuration for business calls as joint
configuration.
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Settings – Subscriber (scr.)
All subscribers
635
Advertisement
Table of Contents
