Table of Contents
Advertisement
Settings – Devices
Voice mail/fax boxes
Enter a sender name that is to be inserted into the top line of a fax along with
the fax ID.
Enter the complete phone number of the own external connection as fax ID.
Number in the format +[country prefix][city code][external phone number]
(e. g. +495306920094).
Fax transmission
ECM (Error Correction Mode)
A maximum of 9600 baud
ECM-Fehlerkorrektur Transmission errors occurring during the trans-
mission (e. g. because of faulty lines) will be corrected provided that EMC
operation (Error Correction Mode) has also been configured for the opposite
end.
Note: If transmission errors occur very often (e. g. overseas lines of
VoIP connections with frequent packet losses), the transmission cannot
be carried out since the fax machines involved will cancel the trans-
mission due to an excessive number of transmission repetitions. In such
cases, it may be sensible to disable EMC error correction. Without EMC
error correction, the transmission errors occurred will be displayed as
erroneous dots or lines..
Maximal 9600 Baud The transmission rate of a fax will be adapted in
such a way that a faultless transmission quality will be reached, where
possible.
Note: The PBX supports a maximum transmission rate of 14400 baud.
This transmission rate may be too high for specific lines (e. g. overseas
718
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Advertisement
Table of Contents
