•
Switching the do-not-disturb function, the call deblocker and restrictor
(incoming) on.
– Using the Configuration Manager (on the following pages)
– For subscriber: Subscriber (scr.) > Properties > Reachability
– For groups (only call restrictor): Groups > Properties > Reacha-
bility
– Using a character string on the internal phone (see chapter Short
Reference > Do-not-disturb/Call Deblocker (Incoming)/Call
Restrictor (Incoming))
– Using the menu/function key on a system phone (optional, see the
phone manual)
Note: As of firmware 6.6 (PBX) and 2.4 (VoIP phone) a comparison
between phone and PBX will be implemented. This function can then be
switched on or off in the phone or the PBX.
•
Configuring the call deblocker and restrictor (incoming) configuration
dependent.
– Using the Configuration Manager (on the following pages)
– For subscribers: Subscriber (scr.) >Profiles > ... > Reachability
– For groups: Groups > Profiles > ... > Reachability
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Do-not-disturb, Call Deblocker and Call Restrictor
Functions, Uses, Concepts
43