Table of Contents
Advertisement
Configure Analogue Door Terminal
Phone number
This is an internal number. You can select any of the numbers in the internal
supply of phone numbers. This number can be called directly by an internal
subscriber. When put together with the numbers of the door bell buttons, this
creates 3 to 4-digit phone numbers. (Select Devices > Device wizard
>
New to enter).
Notes:
A number cannot be allocated twice.
Using numbers with few digits (two- or three-digit numbers) inevitably
restricts the possible supply of numbers that require more digits. For
example, if the phone number 12 is assigned, the phone numbers 120
to 129 and 1200 to 1299 are no longer available.
The default exchange line access number on the PBX is 0 in the factory
settings. However, this can be changed. Note that changing the
exchange line access number restricts the phone numbering plan.
Relay X, Switch input X
Name
Enter the names of the relays and switch inputs.
DTMF sequence
Requirements:
•
Expert settings
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Settings – Devices
Device Wizard
733
Advertisement
Table of Contents
