Table of Contents
Advertisement
Settings – Groups
Properties
(not profile-controlled): The function can not be overridden by a
profile.
Basic settings
Ringing sequence after:
All
All subscribers logged-in to the group will ring simultaneously. Selected
subscribers will start to ring after the configured delay time (after:). If a call
was not accepted, although all logged-in members of the group were called,
the call would be finished with a busy signal.
All - Split Group
The call is handled almost similar to the ringing sequence All. The only
difference is the way multiple calls to the group are handled: If the group
receives further calls during an active call, the group will be split into several
smaller groups ringing for a specific active call. But there will never ring
more calls in the group than the number of free available group members.
Additional calls will be rejected with a busy then. If a call is accepted the
other phones ringing so far for this call are assigned to the other pending
calls and will immediately start to ring again. If a group member finishes a
662
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Advertisement
Table of Contents
