Table of Contents
Advertisement
Hardware
After the first initialisation or the insertion of new modules, these modules
have to be configured using the Configuration Manager. Assign the existing
modules to the used expansion slots and perform the port configuration.
Port configuration is the basic set-up for the inserted modules. The
connection assignments for the ports must be set depending on the proper
use and must be adapted to the actual connection options on site.
Note: Please find the basic information for the use of the modules in the
Installation and Commissioning Instructions.
Proceed as follows for configuration:
•
Selecting modules.
– Using the Configuration Manager (page Hardware > Selection of
modules)
•
Setting port configurations.
– Using the Configuration Manager (page Hardware > Port configu-
ration)
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Functions, Uses, Concepts
Hardware
89
Advertisement
Table of Contents
