Table of Contents
Advertisement
To change the settings of the configured COMmander 2TSM (R)
module, click Configure in the line of the corresponding COMmander
2TSM (R) module on the page Devices > Device wizard.
To reset the COMmander 2TSM (R) module to the default settings of the
device template, on page Hardware > Selection of modules, select the
option not defined and then again 2TSM module in the corresponding
list field. Subsequently, open the page Devices > Device wizard and
configure the COMmander 2TSM (R) module again.
Door Terminals
An existing door terminal can be connected to the PBX so that various door
functions such as speech connection with the door and actuation of the door
opener from internal phones can be carried out. This door terminal must be
created in the configuration of the PBX and allocated an internal number
where it can be called.
The door terminal and the relays and switch inputs (door bell buttons)
available for it can be created with the device wizard. Door calls can be
created for the switch inputs of the door terminal by selecting call destina-
tions. To detect their actuation e. g. because a door bell button has been
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Settings – Devices
Device Wizard
731
Advertisement
Table of Contents
