Table of Contents
Advertisement
Settings – Devices
Alarms
Requirements:
•
Created switch input
CONFIGURATION OF THE SWITCH INPUT
Select the switch input you want to configure.
Level
Requirements:
•
Created switch input for a COMmander 2TSM(R) module
The level must be configured depending on the signal applied.
High level
A voltage of 5-15 V AC/DC was applied.
Low level
GND was applied.
DTMF sequence
Requirements:
•
Created switch input for an analogue device
768
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Advertisement
Table of Contents
