Table of Contents
Advertisement
Room Monitoring
Enabling Room Monitoring (Only at a Single Internal Phone at the
Same Time)
## 8 * 61 #
Additional infor-
mationen
Performing Room Monitoring (from an Internal Phone)
Destination number
Destination
number
Performing Room Monitoring (from an External Phone)
Remote switching number
Remote switching
number
PIN
Additional infor-
mationen
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Subsequently place the receiver next to the phone.
To disable Room Monitoring, replace the receiver.
Internal number of the single phone (for exchange line
request type Direct exchange line phone: with
preceding **)
## 8
Remote switchin number for remote programming
External PIN
You need an analogue DTMF phone, an ISDN phone
with DTMF dialling or an DTMF sender.
Wait for confirmation tone after entering the remote
switching number.
You will hear another confirmation tone after entering
the character string.
If you hear the busy signal, replace the receiver and
start again.
PIN
* 60 #
Short Reference
Room Monitoring
333
Advertisement
Table of Contents
