•
D-channel option selected in the PBX
1. Start the D-channel decoder computer programme.
2. Click Start.
3. In the Interface list field, select the IP option.
4. Enter the IPv4 address or, as of decoder version 2.6.7, the IPv6 address
of the PBX in the IP Address entry field.
Note: If a port is present, omit it when you enter the IP address.
5. Click OK.
The protocol log is displayed.
6. Click Pause to stop the protocol being recording.
Further steps:
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Functions, Uses, Concepts
Service Data
173