Auerswald COMmander 6000 Advanced Information page 746

Settings – Devices
Door Terminals
Click the second
sponding door terminal.
Enter a name for the switch input in the Switch input entry field.
Enter a value under DTMF sequence (for analogue door terminals) or SIP
invite (for VoIP door terminals). To detect that the alarm has been triggered,
e. g. because a door bell button has been pressed, the PBX needs to know
which DTMF sequence or which SIP invite the connected device sends in
this case (see manual and settings of the device in question). The DTMF
sequence or the SIP invite usually is the phone number assigned to the door
bell button within the door terminal.
Only for FTZ door terminals with COMmander 2TSM (R) module: In the Bell
list field, select a switch input.
Note: If all existing switch inputs are assigned to the first door terminal
of the COMmander 2TSM (R) module (basic configuration), the required
switch inputs have to be deleted on the first door terminal.
In the Destination number list field, select the required call destination. Or
after selecting Enter destination number, in the Destination number
entry field, enter the required call destination. Possible entries:
External number
Short-code number
Internal number of the individual phone
Internal phone of the group
Note:
The call destination is first entered identically for all configurations. It can
be changed afterwards.
746
under Door calls + relays in the line for the corre-
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018