Auerswald COMmander 6000 Advanced Information page 213

Pbx for internet/isdn telephony

Hide thumbs Also See for COMmander 6000:

Table of Contents

3. Create internal numbers for the VoIP subscribers.

4. If required, change the automatically generated PINs and passwords.

Note: The user passwords are needed to authenticate the VoIP phones

when they are registered with the PBX.

5. Configure the VoIP end devices. To do this, you need the following infor-

IP address or URL of the PBX

SIP port of the internal VoIP registrar

Internal number of the VoIP subscriber

User password of the VoIP subscriber

Note: You will find notes about how to configure different VoIP end

devices on the Internet (see www.auerswald.de/service).

6. Check whether the VoIP subscriber was successfully registered on the

PBX (page Monitoring > Status int. VoIP subscribers).

7. If necessary, enable DiffServ, to increase VoIP call quality (Quality of

Service (QoS)).

8. If necessary, make the VoIP settings (Jitter buffer, Echo cancellation) for

the VoIP subscribers to improve the call quality.

COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018

Functions, Uses, Concepts

Commander 6000r