Settings – Routing
Soft-LCR 4.0
New
Adds a new subscriber to the list.
Delete
Deletes the entries marked in the list.
Management LCR Providers
Proceed as follows:
•
Using the Configuration Manager (page Routing > Soft-LCR 4.0 >
Provider)
Note:
LCR for Call Through calls is switched on/off on the page Functions
> Call Through under EXCHANGE LINE SETTINGS.
Manual LCR by dialling a preceding provider area code is always
possible if the network provider supports dial-around service.
802
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018