3.1
Operating Mode Selection
This LSI supports only operating mode 7, that is, the advanced single-chip mode. The operating
mode is determined by the setting of the mode pins (MD2 to MD0). Only mode 7 can be used in
this LSI. Therefore, all mode pins must be fixed high, as shown in table 3.1. Do not change the
mode pin settings during operation.
Table 3.1
MCU Operating Mode Selection
MCU
Operating
Mode
MD2 MD1 MD0
7
1
1
3.2
Register Descriptions
The following registers are related to the operating mode. For details on register addresses and
register states during each processing, refer to appendix A, On-Chip I/O Register.
• Mode control register (MDCR)
• System control register (SYSCR)
Section 3 MCU Operating Modes
CPU
Operating
Mode
Description
1
Advanced
Single-chip mode
mode
Section 3 MCU Operating Modes
External Data Bus
On-Chip
Initial
ROM
Width
Enabled —
Rev. 6.00 Mar 15, 2006 page 51 of 570
REJ09B0211-0600
Max
Width
—