Interrupts - Renesas H8S Series Hardware Manual

16-bit single-chip microcomputer

Hide thumbs Also See for H8S Series:

Table of Contents

Section 10 16-Bit Timer Pulse Unit (TPU)

Interrupts

There are three kinds of TPU interrupt source; TGR input capture/compare match, TCNT

overflow, and TCNT underflow. Each interrupt source has its own status flag and enable/disabled

bit, allowing the generation of interrupt request signals to be enabled or disabled individually.

When an interrupt request is generated, the corresponding status flag in TSR is set to 1. If the

corresponding enable/disable bit in TIER is set to 1 at this time, an interrupt is requested. The

interrupt request is cleared by clearing the status flag to 0.

Relative channel priorities can be changed by the interrupt controller, however the priority order

within a channel is fixed. For details, see section 5, Interrupt Controller.

Table 10.36 lists the TPU interrupt sources.

Rev. 6.00 Mar 15, 2006 page 223 of 570

REJ09B0211-0600