Block Transfer Mode; Figure 14.24 Inverse Convention (Sdir = Sinv = O/E = 1) - Renesas H8S Series Hardware Manual
16-bit single-chip microcomputer
Hide thumbs
Also See for H8S Series:
- Hardware manual (1047 pages) ,
- User manual (38 pages) ,
- User manual (26 pages)
Table of Contents
Advertisement
Section 14 Serial Communication Interface (SCI)
With the direction convention type IC and the above sample start character, the logic 1 level
corresponds to state Z and the logic 0 level to state A, and transfer is performed in LSB-first order.
The start character data above is H'3B. For the direct convention type, clear the SDIR and SINV
bits in SCMR to 0. According to Smart Card regulations, clear the O/E bit in SMR to 0 to select
even parity mode.
(Z)
Figure 14.24 Inverse Convention (SDIR = SINV = O/E E E E = 1)
With the inverse convention type, the logic 1 level corresponds to state A and the logic 0 level to
state Z, and transfer is performed in MSB-first order. The start character data for the above is
H'3F. For the inverse convention type, set the SDIR and SINV bits in SCMR to 1. According to
Smart Card regulations, even parity mode is the logic 0 level of the parity bit, and corresponds to
state Z. In this LSI, the SINV bit inverts only data bits D0 to D7. Therefore, set the O/E bit in
SMR to 1 to invert the parity bit for both transmission and reception.
14.7.3
Block Transfer Mode
Operation in block transfer mode is the same as that in SCI asynchronous mode, except for the
following points.
• In reception, though the parity check is performed, no error signal is output even if an error is
detected. However, the PER bit in SSR is set to 1 and must be cleared before receiving the
parity bit of the next frame.
• In transmission, a guard time of at least 1 etu is left between the end of the parity bit and the
start of the next frame.
• In transmission, because retransmission is not performed, the TEND flag is set to 1, 11.5 etu
after transmission start.
• As with the normal Smart Card interface, the ERS flag indicates the error signal status, but
since error signal transfer is not performed, this flag is always cleared to 0.
Rev. 6.00 Mar 15, 2006 page 366 of 570
REJ09B0211-0600
A
Z
Z
A
A
Ds
D7 D6 D5 D4 D3 D2 D1 D0 Dp
A
A
A
A
Z
(Z) state
Advertisement
Table of Contents
