Siemens SINAMICS G120 List Manual page 70

2 Parameters
2.2 List of parameters
Notice: When selecting a catalog motor (p0301), this parameter is automatically pre-assigned and is write protected.
Information in p0300 should be carefully observed when removing write protection.
r0330[0...n] Rated motor slip / Mot slip_rated
Access level: 3
Can be changed: -
Unit group: -
Min
- [Hz]
Description: Displays the rated motor slip.
Dependency: The rated slip is calculated from the rated frequency, rated speed and number of pole pairs.
Refer to: p0310, p0311, r0313
Note: The parameter is not used for synchronous motors (p0300 = 2xx).
r0331[0...n] Actual motor magnetizing current/short-circuit current / Mot I_mag_rtd act
Access level: 3
Can be changed: -
Unit group: -
Min
- [Arms]
Description: Induction motor:
Displays the rated magnetizing current from p0320.
For p0320 = 0, the internally calculated magnetizing current is displayed.
Synchronous motor:
Displays the rated short-circuit current from p0320.
Dependency: If p0320 was not entered, then the parameter is calculated from the rating plate parameters.
r0332[0...n] Rated motor power factor / Mot cos phi rated
Access level: 3
Can be changed: -
Unit group: -
Min
-
Description: Displays the rated power factor for induction motors.
For IEC motors, the following applies (p0100 = 0):
For p0308 = 0, the internally calculated power factor is displayed.
For p0308 > 0, this value is displayed.
For NEMA motors, the following applies (p0100 = 1, 2):
For p0309 = 0, the internally calculated power factor is displayed.
For p0309 > 0, this value is converted into the power factor and displayed.
Dependency: If p0308 is not entered, the parameter is calculated from the rating plate parameters.
Note: The parameter is not used for synchronous motors (p0300 = 2xx).
r0333[0...n] Rated motor torque / Mot M_rated
Access level: 3
Can be changed: -
Unit group: 7_4
Min
- [Nm]
Description: Displays the rated motor torque.
Dependency: IEC drives (p0100 = 0): unit Nm
NEMA drives (p0100 = 1): unit lbf ft
70
Calculated: -
Scaling: -
Unit selection: -
Max
- [Hz]
Calculated: -
Scaling: -
Unit selection: -
Max
- [Arms]
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: p0100
Max
- [Nm]
Data type: FloatingPoint32
Dyn. index: MDS
Func. diagram: -
Factory setting
- [Hz]
Data type: FloatingPoint32
Dyn. index: MDS
Func. diagram: 6722, 6724
Factory setting
- [Arms]
Data type: FloatingPoint32
Dyn. index: MDS
Func. diagram: -
Factory setting
-
Data type: FloatingPoint32
Dyn. index: MDS
Func. diagram: -
Factory setting
- [Nm]
SINAMICS G120 CU250S-2 Control Units
List Manual, 09/2017, A5E33842890