Siemens SINAMICS G120 List Manual page 42

2 Parameters
2.2 List of parameters
r0062 CO: Speed setpoint after the filter / n_set after filter
Access level: 3
Can be changed: -
Unit group: 3_1
Min
- [rpm]
Description: Display and connector output for the speed setpoint after the setpoint filters.
r0063[0...2] CO: Actual speed / Actual speed
Access level: 3
Can be changed: -
Unit group: 3_1
Min
- [rpm]
Description: Display and connector output for the speed actual value.
Frequency components from the slip compensation (for induction motors) are not included.
Index: [0] = Unsmoothed
[1] = Smoothed with p0045
[2] = Calculated from f_set - f_slip (unsmoothed)
Dependency: Refer to: r0021, r0022
Note: The speed actual value r0063[0] – smoothed with p0045 – is additionally displayed in r0063[1]. r0063[1] can be used
as process variable for the appropriate smoothing time constant p0045.
The speed (r0063[2]) calculated from the output frequency and slip can only be compared with the speed actual
value (r0063[0]) in the steady-state.
For U/f control, the mechanical speed calculated from the output frequency and the slip is shown in r0063[2] even if
slip compensation is deactivated.
r0064 CO: Speed controller system deviation / n_ctrl sys dev
Access level: 3
Can be changed: -
Unit group: 3_1
Min
- [rpm]
Description: Displays the actual system deviation of the speed controller.
r0065 Slip frequency / f_Slip
Access level: 3
Can be changed: -
Unit group: 2_1
Min
- [Hz]
Description: Displays the slip frequency for induction motors (ASM).
r0066 CO: Output frequency / f_outp
Access level: 3
Can be changed: -
Unit group: 2_1
Min
- [Hz]
Description: Display and connector output for the unsmoothed output frequency of the power unit.
Frequency components from the slip compensation (induction motor) are included.
42
Calculated: -
Scaling: p2000
Unit selection: p0505
Max
- [rpm]
Calculated: -
Scaling: p2000
Unit selection: p0505
Max
- [rpm]
Calculated: -
Scaling: p2000
Unit selection: p0505
Max
- [rpm]
Calculated: -
Scaling: p2000
Unit selection: p0505
Max
- [Hz]
Calculated: -
Scaling: p2000
Unit selection: p0505
Max
- [Hz]
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: 6020, 6030, 6031
Factory setting
- [rpm]
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: 6020, 6799
Factory setting
- [rpm]
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: 6040
Factory setting
- [rpm]
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: 6310, 6700, 6727,
6730, 6732
Factory setting
- [Hz]
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: 6300, 6700, 6730,
6731, 6799
Factory setting
- [Hz]
SINAMICS G120 CU250S-2 Control Units
List Manual, 09/2017, A5E33842890