Siemens SINAMICS G120 List Manual page 531

p8808[0...53] Identification and Maintenance 3 / I&M 3
CU250S_V_PN Access level: 3
Can be changed: U, T
Unit group: -
Min
-
Description: Parameters for the PROFINET data set "Identification and Maintenance 3" (I&M 3).
This information is known as "Supplementary information".
Dependency: Refer to: p8806, p8807
Notice: Only characters belonging to the standard ASCII character set may be used (32 dec to 126 dec).
Note: An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.
For p8808[0...53]:
Any supplementary information and comments (ASCII).
p8809[0...53] Identification and Maintenance 4 / I&M 4
CU250S_V_PN Access level: 3
Can be changed: U, T
Unit group: -
Min
0000 bin
Description: Parameters for the PROFINET data set "Identification and Maintenance 4" (I&M 4).
This information is known as "Signature".
Dependency: This parameter is preassigned as standard (see note).
After writing information to p8809, p8805 is automatically set to = 1.
Refer to: p8805
Note: For p8805 = 0 (factory setting) the following applies:
Parameter p8809 contains the information described below.
For p8809[0...3]:
Contains the value from r9781[0] "SI change tracking checksum functional".
For p8809[4...7]:
Contains the value from r9782[0] "SI change tracking time stamp checksum functional".
For p8809[8...53]:
Reserved.
r8854 PROFINET state / PN state
CU250S_V_PN Access level: 4
Can be changed: -
Unit group: -
Min
0
Description: State display for PROFINET.
Value: 0:
1:
2:
3:
4:
5:
6:
255:
SINAMICS G120 CU250S-2 Control Units
List Manual, 09/2017, A5E33842890
No initialization
Fatal fault
Initialization
Send configuration
Receive configuration
Non-cyclic communication
Cyclic communications but no setpoints (stop/no clock cycle)
Cyclic communication
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
1111 1111 bin
Calculated: -
Scaling: -
Unit selection: -
Max
255
2 Parameters
2.2 List of parameters
Data type: Unsigned8
Dyn. index: -
Func. diagram: -
Factory setting
Data type: Unsigned8
Dyn. index: -
Func. diagram: -
Factory setting
0000 bin
Data type: Integer16
Dyn. index: -
Func. diagram: -
Factory setting
-
531