Siemens SINAMICS G120 List Manual page 722

2 Parameters
2.5 Parameters for write protection and know-how protection
2.5 Parameters for write protection and know-how protection
2.5.1 Parameters with "WRITE_NO_LOCK"
The following list contains the parameters with the "WRITE_NO_LOCK" attribute.
These parameters are not affected by the write protection.
Product: SINAMICS G120S, Version: 4710100, Language: eng, Type: WRITE_NO_LOCK
p0003
p0010
p0124[0...n]
p0791[0...1]
p0970
p0971
p0972
p2111
p3950
p3981
p3985
p7761
p8805
p8806[0...53]
p8807[0...15]
p8808[0...53]
p8809[0...53]
p9210
p9211
p9400
p9484
2.5.2 Parameters with "KHP_WRITE_NO_LOCK"
The following list contains the parameters with the "KHP_WRITE_NO_LOCK" attribute.
These parameters are not affected by the know-how protection.
Product: SINAMICS G120S, Version: 4710100, Language: eng, Type: KHP_WRITE_NO_LOCK
p0003
p0010
p0124[0...n]
p0791[0...1]
p0970
p0971
p0972
p2040
p2111
p3950
p3981
p3985
p7761
p8805
p8806[0...53]
p8807[0...15]
722
Access level / Acc_level
Drive commissioning parameter filter / Drv comm. par_filt
CU detection via LED / CU detection LED
CO: Fieldbus analog outputs / Fieldbus AO
Reset drive parameters / Drive par reset
Save parameters / Save par
Drive unit reset / Drv_unit reset
Alarm counter / Alarm counter
Service parameter / Serv par
Acknowledge drive object faults / Ackn DO faults
Master control mode selection / PcCtrl mode select
Write protection / Write protection
Identification and maintenance 4 configuration / I&M 4 config
Identification and Maintenance 1 / I&M 1
Identification and Maintenance 2 / I&M 2
Identification and Maintenance 3 / I&M 3
Identification and Maintenance 4 / I&M 4
Flashing component number / Flash comp_no.
Flash function / Flash fct.
Safely remove memory card / Mem_card rem
BICO interconnections search signal source / BICO S_src srch
Access level / Acc_level
Drive commissioning parameter filter / Drv comm. par_filt
CU detection via LED / CU detection LED
CO: Fieldbus analog outputs / Fieldbus AO
Reset drive parameters / Drive par reset
Save parameters / Save par
Drive unit reset / Drv_unit reset
Fieldbus interface monitoring time / Fieldbus t_monit
Alarm counter / Alarm counter
Service parameter / Serv par
Acknowledge drive object faults / Ackn DO faults
Master control mode selection / PcCtrl mode select
Write protection / Write protection
Identification and maintenance 4 configuration / I&M 4 config
Identification and Maintenance 1 / I&M 1
Identification and Maintenance 2 / I&M 2
SINAMICS G120 CU250S-2 Control Units
List Manual, 09/2017, A5E33842890