Siemens SINAMICS G120 List Manual page 201

r1112 CO: Speed setpoint after minimum limiting / n_set aft min_lim
Access level: 4
Can be changed: -
Unit group: 3_1
Min
- [rpm]
Description: Displays the speed setpoint after the minimum limiting.
Dependency: Refer to: p1091, p1092, p1093, p1094, p1101
p1113[0...n] BI: Setpoint inversion / Setp inv
CU250S_V_DP Access level: 3
CU250S_V_PN
Can be changed: T
Unit group: -
Min
-
Description: Sets the signal source to invert the setpoint.
Dependency: Refer to: r1198
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
p1113[0...n] BI: Setpoint inversion / Setp inv
CU250S_V Access level: 3
CU250S_V_CAN
Can be changed: T
Unit group: -
Min
-
Description: Sets the signal source to invert the setpoint.
Dependency: Refer to: r1198
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
p1113[0...n] BI: Setpoint inversion / Setp inv
CU250S_V (EPOS) Access level: 3
CU250S_V_CAN
Can be changed: T
(EPOS)
Unit group: -
CU250S_V_DP
(EPOS)
Min
CU250S_V_PN
-
(EPOS)
Description: Sets the signal source to invert the setpoint.
Dependency: Refer to: r1198
Notice: The parameter may be protected as a result of p0922 or p2079 and cannot be changed.
SINAMICS G120 CU250S-2 Control Units
List Manual, 09/2017, A5E33842890
Calculated: -
Scaling: p2000
Unit selection: p0505
Max
- [rpm]
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
2 Parameters
2.2 List of parameters
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: 3050
Factory setting
- [rpm]
Data type: U32 / Binary
Dyn. index: CDS, p0170
Func. diagram: 2441, 2442, 2505,
3040
Factory setting
[0] 2090.11
[1] 0
[2] 0
[3] 0
Data type: U32 / Binary
Dyn. index: CDS, p0170
Func. diagram: 2441, 2442, 2505,
3040
Factory setting
[0] 722.1
[1] 0
[2] 0
[3] 0
Data type: U32 / Binary
Dyn. index: CDS, p0170
Func. diagram: 2441, 2442, 2505,
3040
Factory setting
0
201