Siemens SINAMICS G120 List Manual page 568

2 Parameters
2.2 List of parameters
p9659 SI forced checking procedure timer / SI FCP Timer
Access level: 3
Can be changed: C(95)
Unit group: -
Min
0.00 [h]
Description: Sets the time interval for carrying out the forced checking procedure and testing the Safety switch-off signal paths.
Within the parameterized time, STO must have been de-selected at least once. The monitoring time is reset each
time that STO is de-selected.
Dependency: Refer to: A01699
Note: STO: Safe Torque Off
r9660 SI forced checking procedure remaining time / SI FCP remain
Access level: 3
Can be changed: -
Unit group: -
Min
- [h]
Description: Displays the time remaining before dynamization and testing of the safety switch-off signal paths (forced checking
procedure).
Dependency: Refer to: A01699
p9661 SI forced checking procedure STO via PM terminals time / FCP_dyn STO PM-T t
Access level: 3
Can be changed: C(95)
Unit group: -
Min
0.00 [h]
Description: Sets the time interval for monitoring the forced checking procedure and testing the Safety switch-off signal paths for
STO via terminals on the Power Module.
Within the parameterized time, STO must have been de-selected at least once.
Dependency: Refer to: r9662
Refer to: A01678
Note: STO: Safe Torque Off
r9662 SI forced checking procedure STO via PM terminals remaining time /
FCP_dyn STO PM-T t
Access level: 3
Can be changed: -
Unit group: -
Min
- [h]
Description: Displays the remaining time for monitoring the forced checking procedure and testing the Safety switch-off signal
paths for STO via terminals on the Power Module.
After the monitoring time set in p9661 has expired, an appropriate alarm is output.
Dependency: Refer to: p9661
Refer to: A01678
Note: PM: Power Module
STO: Safe Torque Off
568
Calculated: -
Scaling: -
Unit selection: -
Max
9000.00 [h]
Calculated: -
Scaling: -
Unit selection: -
Max
- [h]
Calculated: -
Scaling: -
Unit selection: -
Max
9000.00 [h]
Calculated: -
Scaling: -
Unit selection: -
Max
- [h]
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: 2810
Factory setting
8.00 [h]
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: -
Factory setting
- [h]
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: -
Factory setting
8.00 [h]
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: -
Factory setting
- [h]
SINAMICS G120 CU250S-2 Control Units
List Manual, 09/2017, A5E33842890