Siemens SINAMICS G120 List Manual page 454

2 Parameters
2.2 List of parameters
p3332[0...n] BI: 2/3 wire control command 3 / 2/3 wire cmd 3
Access level: 3
Can be changed: U, T
Unit group: -
Min
-
Description: Sets the signal source for command 3 for the two-wire control/three-wire control.
Dependency: Refer to: p0015, p3330, p3331, r3333, p3334
Note: The mode of operation of this binector input is dependent on the wire control set in p0015.
r3333.0...3 CO/BO: 2/3 wire control control word / 2/3 wire STW
Access level: 3
Can be changed: -
Unit group: -
Min
-
Description: Displays the control word for the two wire control/three wire control.
The control signals are dependent on the wire control set in p0015 and the signal states at the digital inputs.
Bit field: Bit
00
01
02
03
Dependency: Refer to: p0015, p3330, p3331, p3332, p3334
p3334 2/3 wire control selection / 2/3 wire select
Access level: 4
Can be changed: U, T
Unit group: -
Min
0
Description: Sets the two wire control/three wire control.
Value: 0:
1:
2:
3:
4:
Dependency: Refer to: p0015, p3330, p3331, p3332, r3333
Note: This value depends on the wire control set in p0015.
p3340[0...n] BI: Limit switch start / Lim switch start
Access level: 3
Can be changed: T
Unit group: -
Min
-
Description: Sets the signal source for the start of motion dependent on the sign of the setpoint.
Dependency: Refer to: p3342, p3343, r3344
Refer to: A07352
454
Signal name
ON
Reversing
ON inverted
Reversing inverted
No wire control
Two wire control clockwise/counterclockwise 1
Two wire control clockwise/counterclockwise 2
Three wire control enable clockwise/counterclockwise
Three wire control enable ON/reversing
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
1 signal
Yes
Yes
Yes
Yes
Calculated: -
Scaling: -
Unit selection: -
Max
4
Calculated: -
Scaling: -
Unit selection: -
Max
-
Data type: U32 / Binary
Dyn. index: CDS, p0170
Func. diagram: 2273
Factory setting
0
Data type: Unsigned32
Dyn. index: -
Func. diagram: 2272, 2273
Factory setting
-
0 signal
No
No
No
No
Data type: Integer16
Dyn. index: -
Func. diagram: 2272, 2273
Factory setting
0
Data type: U32 / Binary
Dyn. index: CDS, p0170
Func. diagram: -
Factory setting
0
SINAMICS G120 CU250S-2 Control Units
List Manual, 09/2017, A5E33842890
FP
-
-
-
-