Quick Commissioning (P0010 = 1) - Siemens SINAMICS G120 List Manual

Table 2-7
Par. no.
p1300
p1500
p1900
p1905
p2196
p3900
If p0010 = 1 is selected, p0003 (user access level) can be used to select the parameters that
are to be accessed.
At the end of the quick commissioning, set p3900 = 1 to perform the required motor
calculations and reset all other parameters (not included in p0010 = 1) to their default settings.
Note
This only applies for the quick commissioning.
SINAMICS G120 CU250S-2 Control Units
List Manual, 09/2017, A5E33842890
Quick commissioning (p0010 = 1), continued
Name
Open-loop/closed-loop control operating mode
Torque setpoint selection
Motor data identification and rotating measurement 1
Parameter tuning selection
Torque utilization scaling
Completion of quick commissioning

2.6 Quick commissioning (p0010 = 1)

Access level
2
2
1
1
1
2 Parameters
Can be
changed
C(1)T
C(1)T
C(1)T
C(1)T
C(1,3)UT
C(1)
725