Siemens SINAMICS G120 List Manual page 582

2 Parameters
2.2 List of parameters
r9781[0...1] SI checksum to check changes (processor 1) / SI chg chksm P1
Access level: 3
Can be changed: -
Unit group: -
Min
-
Description: Displays the checksum for tracking changes for Safety Integrated.
These are additional checksums that are created to track changes (fingerprint for the "safety logbook" functionality) to
safety parameters (that are relevant for checksums).
Index: [0] = SI checksum to track functional changes
[1] = SI checksum to track hardware-specific changes
Dependency: Refer to: p9601, p9729, p9799
Refer to: F01690
r9782[0...1] SI time stamp to check changes (processor 1) / SI chg t P1
Access level: 3
Can be changed: -
Unit group: -
Min
- [h]
Description: Displays the time stamps for the checksums for tracking changes for Safety Integrated.
The time stamps for the checksums for tracking changes (fingerprint for the "safety logbook" functionality) made to
safety parameters are saved in parameters p9781[0] and p9781[1].
Index: [0] = SI time stamp for checksum to track functional changes
[1] = SI time stamp for checksum to track hardware-specific changes
Dependency: Refer to: p9601, p9729, p9799
Refer to: F01690
r9784[0...1] SI Motion diagnostics sensorless acceleration / Diag sl a
Access level: 3
Can be changed: -
Unit group: -
Min
- [rev/s²]
Description: Display to diagnose acceleration values of the encoderless actual values sensing.
Index: [0] = Setpoint acceleration value
[1] = Actual acceleration value
Dependency: Refer to: p9589
Note: For index 0:
Shows the parameterized acceleration value of p9589.
For index 1:
Shows the actually measured acceleration values of the encoderless actual value sensing
r9785[0...1] SI Motion diagnostics sensorless minimum current / Diag sl I_min
Access level: 3
Can be changed: -
Unit group: 6_3
Min
- [mA]
Description: Display to diagnose currents of the encoderless actual value sensing.
Index: [0] = Minimum current parameterized
[1] = Minimum current measured
Dependency: Refer to: p9588
582
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
- [h]
Calculated: -
Scaling: -
Unit selection: -
Max
- [rev/s²]
Calculated: -
Scaling: -
Unit selection: p0505
Max
- [mA]
Data type: Unsigned32
Dyn. index: -
Func. diagram: -
Factory setting
-
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: -
Factory setting
- [h]
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: -
Factory setting
- [rev/s²]
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: -
Factory setting
- [mA]
SINAMICS G120 CU250S-2 Control Units
List Manual, 09/2017, A5E33842890