Siemens SINAMICS G120 List Manual page 399

p2549 BI: LR enable 1 / Enable 1
CU250S_V (Position Access level: 1
control)
Can be changed: T
CU250S_V_CAN
Unit group: -
(Position control)
Min
CU250S_V_DP
-
(Position control)
CU250S_V_PN
(Position control)
Description: Sets the signal source for the position controller enable 1.
Dependency: Refer to: r0899, p2550
Note: The position controller is enabled by the following AND logic operation:
- BI: p2549
- BI: p2550
p2550[0...n] BI: LR enable 2 / Enable 2
CU250S_V (Position Access level: 1
control)
Can be changed: T
CU250S_V_CAN
Unit group: -
(Position control)
Min
CU250S_V_DP
-
(Position control)
CU250S_V_PN
(Position control)
Description: Sets the signal source for the position controller enable 2.
Dependency: Refer to: p2549
Note: The position controller is enabled by the following AND logic operation:
- BI: p2549
- BI: p2550
p2551 BI: LR setpoint signal fixed / Mess setp fixed
CU250S_V (Position Access level: 1
control)
Can be changed: T
CU250S_V_CAN
Unit group: -
(Position control)
Min
CU250S_V_DP
-
(Position control)
CU250S_V_PN
(Position control)
Description: Sets the signal source for the "setpoint fixed" signal.
BI: p2551 = 1 signal:
The end of the positioning operation on the setpoint side is signaled and the positioning and standstill monitoring
activated.
BI: p2551 = 0 signal:
The start of a positioning operation or tracking mode on the setpoint side is signaled and the positioning and standstill
monitoring deactivated.
Dependency: Refer to: p2554, r2683
SINAMICS G120 CU250S-2 Control Units
List Manual, 09/2017, A5E33842890
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
2 Parameters
2.2 List of parameters
Data type: U32 / Binary
Dyn. index: -
Func. diagram: 4015
Factory setting
899.2
Data type: U32 / Binary
Dyn. index: CDS, p0170
Func. diagram: 4015
Factory setting
1
Data type: U32 / Binary
Dyn. index: -
Func. diagram: 4020
Factory setting
2683.2
399