Siemens SINAMICS G120 List Manual page 577

r9765 SI Motion forced checking procedure remaining time (processor 1) /
SI Mtn dyn rem P1
Access level: 3
Can be changed: -
Unit group: -
Min
- [h]
Description: Displays the time remaining until the next dynamization and testing of the safety motion monitoring functions
integrated in the drives.
The signal source to initiate the forced checking procedure is parameterized in p9705.
Dependency: Refer to: p9705
Refer to: C01798
r9768[0...7] SI PROFIsafe receive control words (processor 1) / SI Ps PZD recv P1
CU250S_V_DP Access level: 3
CU250S_V_PN
Can be changed: -
Unit group: -
Min
-
Description: Displays the received PROFIsafe telegram on processor 1.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
Dependency: Refer to: r9769
Note: The PROFIsafe trailer at the end of the telegram is also displayed (2 words).
r9769[0...7] SI PROFIsafe send status words (processor 1) / SI Ps PZD send P1
CU250S_V_DP Access level: 3
CU250S_V_PN
Can be changed: -
Unit group: -
Min
-
Description: Displays the PROFIsafe telegram to be sent on processor 1.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
Dependency: Refer to: r9768
Note: The PROFIsafe trailer at the end of the telegram is also displayed (2 words).
SINAMICS G120 CU250S-2 Control Units
List Manual, 09/2017, A5E33842890
Calculated: -
Scaling: -
Unit selection: -
Max
- [h]
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
2 Parameters
2.2 List of parameters
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: -
Factory setting
- [h]
Data type: Unsigned16
Dyn. index: -
Func. diagram: -
Factory setting
-
Data type: Unsigned16
Dyn. index: -
Func. diagram: -
Factory setting
-
577