Siemens SINAMICS G120 List Manual page 538

2 Parameters
2.2 List of parameters
p8983 Ethernet/IP ODVA torque scaling / Eth/IP ODVA M scal
CU250S_V_PN Access level: 3
Can be changed: T
Unit group: -
Min
123
Description: Sets the scaling for the torque for Ethernet/IP ODVA profile (p8980 = 1).
Value: 123:
124:
125:
126:
127:
128:
129:
130:
131:
132:
133:
Dependency: Refer to: p8980
Note: Changes only become effective after POWER ON.
The parameter is not influenced by setting the factory setting.
p8991 USB memory access / USB mem acc
Access level: 3
Can be changed: T
Unit group: -
Min
1
Description: Selects the storage medium for access via the USB mass storage.
Value: 1:
2:
Note: A change only becomes effective after a POWER ON.
The parameter is not influenced by setting the factory setting.
p8999 USB functionality / USB Fct
Access level: 4
Can be changed: T
Unit group: -
Min
1
Description: Setting the USB functionality.
Value: 1:
2:
3:
Note: COMM: Commissioning.
A change only becomes effective after a POWER ON.
The parameter is not influenced by setting the factory setting.
538
32
16
8
4
2
1
0.5
0.25
0.125
0.0625
0.03125
Memory card
Flash r/w internal
USS commissioning via the virtual COM port
Only memory access
USB commissioning and memory access
Calculated: -
Scaling: -
Unit selection: -
Max
133
Calculated: -
Scaling: -
Unit selection: -
Max
2
Calculated: -
Scaling: -
Unit selection: -
Max
3
Data type: Integer16
Dyn. index: -
Func. diagram: -
Factory setting
128
Data type: Integer16
Dyn. index: -
Func. diagram: -
Factory setting
1
Data type: Integer16
Dyn. index: -
Func. diagram: -
Factory setting
3
SINAMICS G120 CU250S-2 Control Units
List Manual, 09/2017, A5E33842890